cantilevers
英
美
网络 悬臂; 悬臂桁架; 悬臂梁
双语例句
- The following main groups of cantilevers are used in the overhead line system equipment design.
以下几组腕臂主要用于架空线路系统设备设计。 - Due to the torque of the joint, the elevated heights of the two kinds of cantilevers assembled with the mirror plates are much smaller than those of the free end of the cantilevers.
由于支撑壁与镜体的连接处存在扭矩，微镜的提升高度远小于支撑臂自由端的提升高度。 - STABILITY OF MONOSYMMETRIC I-SECTION CANTILEVERS Analysis on overall buckling behaviour of ultra-high strength steel columns by ANSYS
单轴对称工字形截面悬臂钢梁在横向荷载作用下的整体稳定性研究运用ANSYS分析超高强度钢材钢柱整体稳定特性 - This paper presented a silicon-based scanning micromirror actuated by piezoelectric cantilevers using PZT.
设计并研究了一种硅基PZT压电悬臂梁驱动扫描微镜器件。 - The bilayer cantilevers, formed with a polysilicon layer and a gold layer, elevate the mirror plate according to residual stress-induced bending.
支撑臂由多晶硅层和金层构成，在残余应力的作用下发生弯曲而将镜体提起。 - The upper body of the dam, having lost the assistance of the cantilevers, now behaves predominantly as a horizontal arch.
上部坝体已丧失掉悬臂梁的辅助作用，现在主要表现出一个水平拱圈的性状。 - The cantilevers are the supports for the catenary and working in the manner of a fixation point.
腕臂是悬链线的支撑，并以定点方式操作。 - In this paper, analysis on the stability of monosymmetric I-section cantilevers for four cross sections has been made to assist practice use.
单轴对称截面悬臂梁的整体稳定性，国内外的理论及试验研究都存在明显的不足，限制了实际应用。 - In this paper we have designed and fabricated the ultra-sensitive cantilevers for single electron spin detection.
提出一种用于单电子自旋探测微悬臂梁的制作方法。 - Cantilevers enabled bridge builders to span longer distances than truss bridges. During the nineteenth century, cantilevers were frequently used to build railroad bridges.
悬臂桥使得桥梁建筑师能够修比桁架跨度更大的桥梁。在19世纪悬臂桥常常是铁路桥。 - Adopting the double cantilevers;
采用双腕臂； - Structural Design of Novel Micro Piezoelectric Cantilevers with Low Stiffness and High Resonance Frequency
低刚度高谐振频率的新型微压电悬臂梁探针的结构设计 - Moreover, high mode micromechanical resonant cantilevers feature higher Q factor and sensitivity compared to the fundamental mode.
微机械悬臂梁在高阶谐振模态下具有更高的品质因数和灵敏度，而其等效质量不变，因此可以获得更高的质量检测分辨率。 - Analysis of transverse internal forces in box girder bridges with cantilevers
带伸臂箱梁桥横向内力分析 - While for cantilevers under transverse loads, the newer theory is not correct.
另一方面，对于横向荷载作用下的悬臂梁，较新理论则存在问题。 - The effectiveness based on cracked section of columns in integral structural analysis and the impact analysis for vibration of the long cantilevers are also discussed.
文中对开裂截面柱在结构整体分析中引起的刚度和内力分配的变化，以及对该高位盘旋结构所做的随机振动的冲击分析都作了一定的论述。 - Fast Frequencies Measurement Method for Dual Sinusoidal Signals adopting the double cantilevers;
一种双正弦信号的快速频率测量方法采用双腕臂； - The most of the successful micro machined sensors adopt the construction of micro cantilevers. For example, the resonant pressure micro sensors, and the micro machined force-balance capacitive accelerometers.
而较成功的微机电传感器，如谐振式压力传感器和力平衡式电容微加速度传感器，均采用了微悬臂梁结构。 - Besides rectangular shaped cantilevers with both piezoresistive sensor and electric heater, the "V" and "U" type cantilevers are also formed for electric-heating probes.
在研究了等截面悬臂梁结构纳机电探针之后，本文还研究了在悬臂梁自由端集成了加热电阻的V型和U型悬臂梁维构纳机电探针。 - This device is composed of grating plate, four cantilevers and address electrode, the phase modulation of incident light is performed for achieving the switching of light via piston-type motion of suspending grating, therefore, the grating light modulator array can be used for projection displays.
器件主要由3个部分组成：光栅、4个悬臂梁和地址电极。悬空的光栅活塞式运动可对光进行相位调制以实现光的开关态，器件阵列可用于投影显示； - In order to simulate shear failure and torsion failure, SMT applied a force through a probe to push micro cantilevers at the fixed end and free end respectively until they failed.
为模拟横力剪切破坏和扭转破坏工况，用微力学测试仪分别在悬臂梁的固定端和自由端施加载荷至试样破坏。 - The microfabrication techniques for piezoelectric unimorph cantilevers were investigated.
对压电双晶梁结构进行了微型化工艺研究。 - In this paper, the construction methods for cantilevers of the V-shape piers and closure of V-shape structure are presented, and the selection of construction schemes, closure sequences of V-shape structure, temporary horizontal prestressing techniques and construction simulation calculation method are detailed.
介绍该桥V形墩臂和V构合拢的施工方法，着重论述了方案的优选、V构合拢和临时水平预应力技术措施及其模拟计算方法。 - Design of profiled bar with big cantilevers used for radiator
大悬臂散热器型材模具的设计 - An electrostatically actuated in-situ measuring method for average stress gradient and equivalent elastic modulus of the film is proposed based on pull-in voltages of a set of cantilevers. The key of the measuring method is to realize rapid and accurate calculation of pull-in voltages of the cantilever.
提出了一种利用静电作用下悬臂梁的吸合电压提取薄膜沿厚度方向的平均应力梯度及等效弹性模量的方法，该方法的关键在于实现悬臂梁吸合电压的快速精确计算。 - The relations between the steel concrete slips and the studs 'loading forces of two kinds of simply supported composite beams with one or two cantilevers respectively are studied.
研究了单伸臂简支组合梁和双伸臂简支组合梁钢与混凝土板之间相对滑移和栓钉受力的关系； - The PC continuous box girder with transverse long cantilevers is widely applied in urban bridge due to reducing abutment size and its number and increasing clearance under the bridge.
预应力混凝土横向大悬臂连续箱梁桥由于其可以减少墩台数目或减小墩台尺寸、节省工程量，增加桥下净空，所以在城市桥梁中得到广泛应用。 - The effect of cantilever tilt angle, in-plane deformation, contact stiffness and tip position on effective spring constants of cantilevers are detailed discussed.
计算结果表面微悬臂梁安装倾斜角度、针尖安装位置、接触刚度和面内形变对微悬臂梁等效刚度具有较大影响。 - The impedance analysis method can measure cantilevers with any size and structure, but it only can measure the frequecy modal of the piezoelectric cantilever.
而阻抗分析法可测量任意尺寸和结构的悬臂梁，但此方法只能测量压电梁的模态频率。 - Signal characteristics of high resonance frequency PZT cantilevers are analyzed with the theory of piezoelectric micro-cantilevers.
运用压电微悬臂梁相关理论，分析了高谐振频率的PZT压电微悬臂梁的信号特征。