Now the trace you notice on the left side has very few and very sharp deflections. 现在大家注意到左侧的变位,很少但是很剧烈。
The results showed that: both two maximal deflections were at the middle point of end span; 发现两者最大挠度都发生在受火边跨;
The major application of these data is to define the control deflections required to stabilize the vehicle. 这些数据的主要应用是确定稳定飞行器所需要的控制偏角。
Where required, to examine deflections, stiffness requirements, and any special material and design provisions to obviate brittle fracture under adverse conditions. 必要时验算挠度、刚度要求、以及任一特殊材料和设计规定,以预防不利条件下的脆断。
The associated permitted deflections shall be included in the contract documents. 相关许可挠度应当包含在合同文件中。
The structural analysis is based on a quadrilateral flat-shell element and an updated Lagrange ( UL) formulation, which can be employed to model geometric nonlinearities arising from large deflections. 结构部分以四边形平板壳元为基础,采用更新的拉格朗日(UL)方法分析结构大变形引起的几何非线性问题。
However, while some building codes provide methods for estimating shear wall deflections, these methods are not adequate for shear walls without hold-downs. 尽管有些国家的建筑规范中已给出了估算木结构剪力墙侧向变形的方法,但这些方法并不适用于无抗倾覆锚固件木结构剪力墙。
This renders the bearing like other self-aligning bearings, impervious to misalignments and shaft deflections. 有这种装置的轴承就像自调整轴承,可以避免误差和轴倾斜。
Novel system for measuring bridge deflections based on laser and video 基于激光和视频的桥梁挠度测量新系统
Analysis to Large Deflections of Elastic Cantilever Beam with Constraint under Uniformly Distributed Load 均布载荷下变形受约束悬臂梁弹性大变形分析
In this paper, a new method to measure meshing composite deflections of loaded cylindrical involute helical gear by using high precision clinometer is presented. 提出利用高精度测角仪测量齿轮副在啮合过程中不同啮合位置时轮齿受载综合变形的新方法。
The effects of some parameters, such as the plate thickness, radius of the filled foundation, on the maximum deflections and stress, are also investigated. 最后研究了盖层厚度、填充半径对位移、应力的影响规律。
The deflections of throttle slices were analyzed and the equivalent relations of flux distribution were deduced according to the structure of self-designed hydro-pneumatic spring. 根据自主研发阻尼可调油气弹簧的结构形式,分析了叠加节流阀片的挠曲变形量,给出系统流量分配的等效关系。
The pace analyzes the current pre-arched calculation and installation method based on the relative deflections, and proposes a new absolute deflection method. 本文在对现行的基于相对挠度的预拱度计算设置方法进行分析后,进而提出了新的绝对挠度法。
The test results showed that the fracture deflections of the composite coatings and the fractal dimensions of the fractured surfaces decreased with increasing the contents of hard phases. 测量了多相材料复合涂层的断裂挠度和断口表面的分形维数,分析了复合涂层的断裂特征结果表明:随着硬质相增加,复合涂层的断裂挠度和断口表面的分形维数降。
Vertical elements carry sufficient load through cantilever action to produce cantilever deflections equal to arch deflections. 垂直杆件则借悬臂作用产生和拱挠度相等的悬臂挠度,来承担足够的荷载。
But, more significantly, the overturning moment and the shear deflections produced by lateral forces are much larger and must be carefully provided for. 更重要的是侧向里所产生的倾覆力矩和剪力变形要大的多,必要谨慎设计来保证。
Experimental results indicate that the cracks weaken the strength of slabs, lower their stiffness, and induce the deflections of slabs beyond limit. 试验结果表明,支座边的裂缝严重削弱了板的承载力,降低了楼板的刚度,导致楼板的挠度过大。
And on the right, you notice that there are many of those sharp deflections. 在右侧,大家看到,有很多明显的变位。
The deflections of the vertical happen to be known in this case ( see below). 垂直偏斜碰巧在此例中有证明(看下图)。
Unsteady Transonic Flow Computation for a Wing with Control Surface Deflections by Euler Equations 跨声速机翼操纵面非定常气动力Euler方程计算
In geometric nonlinearity, the effects of instability produced by axial forces, the bowing of the deformed members, and finite deflections have all been included. 在几何非线性的影响下,所产生不稳定的轴向力、弯曲变形产生的弯矩,以及有限制的偏移量均包括在内。
Equations are established based on the principle of deflections consistency. 根据板簧变形协调原理,导出相应的方程。
They observed the deflections of the particles by allowing them to fall on a fluorescent screen. 他们让粒子落在荧光屏上以观察他们的偏移。
An increase in resistance to roll deflections may be gained by splitting the single strut into a fork at the top. 采用上部分呈叉状的单支杆可以增强抗滚转变形性能。
When aerodynamic solution and structural deflections are both converged, the aerodynamic characteristic of the elastic wing is obtained. 将非线性气动力与结构线化机翼弹性变形耦合迭代求解。
So the deflections of concrete beams prestressed with bonded FRP tendons are expected to be larger than those of the steel bars cases. 国内外已有试验研究表明,有粘结预应力FRP筋混凝土梁的破坏模式包括界限破坏、受压破坏与受拉破坏三种。
The effects of deflections are evaluated during the process of calibrating the balance. 变形影响是在天平校准的过程中测量的。
The deflections of the blades under different wind speeds and different rotating time were given to validate the reliability of the model presented herein. 研究结果对风力机叶片的振动特性和疲劳寿命预测以及高性能叶片的设计有理论指导意义。
We may use the plane stress analysis for determining deflections in the midplane of the beam. 我们可以用平面压力的分析方法来确立梁中间面的挠度。