Analyze the clock feedthrough error of the first-generation switched-current memory-cell and design a high performance switched-current memory-cell. 对第一代开关电流存储单元产生的时钟馈通误差做了合理的近似分析,设计了一种高性能开关电流存储单元。
Structural Design and Heat Transfer Calculation of Cryostat Feedthrough Auxiliary Supports for ITER ITER过渡馈线辅助支撑结构设计及传热计算
Position the power and ground feedthrough or abutment pins so that they align with corresponding pins in other cells. 要把电源和接地的引脚贯穿放置以便于电源和地对齐。
Stable decoupling of square linear systems with direct feedthrough 带有纯放大环节的方线性系统的稳定解耦
Structural design and optimization of cryostat feedthrough for ITER magnet ITER磁体过渡馈线的结构设计与优化
Rayleigh-Taylor Instability of Feedthrough Growth in a Spherical Shell Geometry 球壳结构馈通增长的瑞利-泰勒不稳定性
A bootstrapped switch with dummy transistor is used to reduce the signal-dependent charge injection and clock feedthrough. 采用增加哑开关管的自举开关,消除与输入有关的电荷注入和时钟馈通;
Round-trip Feedthrough Effects in Raman Spectra of LinbO_3 and LiTAO_3 LiNbO3和LiTaO3拉曼光谱中的反复转馈现象
How to Eliminate Hidden Danger out of Explosion Existed in Tool Retracting Groove of Feedthrough Joint 如何消除联通节中退刀槽存在的失爆隐患
A Clock-Feedthrough Compensation Technology for Switched-Current Circuits 一种开关电流电路时钟馈通的补偿技术
It reasonably determines the interconnecting set of wire, assigns wires to layers, defines the order of wire layout, and uses feedthrough holes and obstacle walls so that it can increase the routing efficiency and save the computer time. 它采用李氏算法,吸收了人工布线的经验,合理地进行分线、分层、定顺序、使用借孔及障碍墙等,以提高布线的效率。
A high performance CMOS charge pump is designed to overcome the disadvantage in the traditional charge pump circuit, including charge injection, clock feedthrough, charge sharing and charge/ discharge mismatches. 本文针对传统电荷泵电路中的电荷注入、时钟馈通、电荷共享和充放电失配等非理想因素,设计了一种高精度电荷泵,降低了锁相环(PLL)的相位噪声。
The feedthrough is special and high precise parts in drift chamber. 定位子是漂移室的精密部件,专用性强,结构精度高。
Using the direct relationship between Yokoyama canonical form and transfer 'function matrix, we give a sufficient and necessary condition for the stable decoupling of square linear system with direct feedthrough by using the constructure approach. 本文利用Yokoyama中标准形与系统传递函数阵间的直接对应关系,用构造性方法给出了带纯放大环节的方线性系统稳定解耦问题有解的充分必要条件。
Rayleigh-Taylor Instability of Feedthrough Growth In an Incompressible Convergent Geometry 不可压结构聚合运动耦合增长的瑞利-泰勒不稳定性研究
In the fourth chapter, we discuss the passivation control problem for a class of nonlinear system with disturbance uncertainty and feedthrough term. 在第四章中,提出并考察了一类带有馈通项的不确定性非线性系统的反馈鲁棒无源控制问题。
In this paper, the intersection problem of compensating spectra and closed-loop spectra for decentralized systems with direct control feedthrough is studied by the properties of singular decentralized systems. 本文利用广义分散系统的性质,解决了带前通的分散系统的补偿谱与闭环谱相交性问题。
In this paper, a novel packaging structure model which is performed using wafer level micropackaging on the thin silicon substrate as the Ka band distributed MEMS phase shifters wafer with vertical feedthrough is presented. 本文提出一种适用于Ka波段分布式MEMS移相器的新型封装结构&具有垂直互连线的薄硅作为分布式MEMS移相器衬底,并用芯片微封装方法对移相器进行封装。
Clock Feedthrough Effects in Switched-Current Circuits 开关电流电路中的时钟馈入效应
A switch with two pseudo-MOSFETs which reduces clock-feedthrough is presented; 采用两个伪MOS管的开关,防止了时钟馈通;
Structural Design and Analysis of Cryostat Feedthrough for International Thermonuclear Experimental Reactor 国际热核聚变实验堆过渡馈线设计与分析
Bottom-planking-sampling and virtual devices effectively eliminate charge injection and clock feedthrough; 通过底极板采样技术和虚拟器件有效地消除了电荷注入及时钟馈通。
Development of Conductor Feedthrough Module of LV Electrical Penetration Assembly for Research Reactors 研究堆低压电气贯穿件导体组件的研制
The control signals couple through the capacitance of the switches to the output, the dynamic error caused by the parasitic gate – drain feedthrough capacitance is significantly lowered by the use of a reduced voltage swing at the input of the switches. 差分开关的控制信号会通过晶体管的寄生电容耦合到输出,从而影响DAC的动态性能,设计中通过降低控制信号电压的方法来解决这个问题。
This adaptive controller needs to solve three types of parameters, that is, phase advance parameters, adaptive gains and feedthrough coefficients. 这种自适应补偿器需要求解三个参变量,即相位超前参数、自适应增益和前馈项系数。
One of the most important errors is the switching transient non-ideal behavior including clock feedthrough effect, asymmetric switching and switching timing errors. 其中,最重要的误差就是开关过程中的瞬态非理想行为。开关的瞬态非理想行为包括:时钟馈通效应、非对称式开关过程和开关时序误差。
The optimization of sample-and-hold circuit relieves the high-speed sampling clock feedthrough and charge injection effect. 前端采样保持电路的优化有效缓解了高速采样下的时钟馈通和电荷注入效应,缓冲级巧妙地将衬底电容与输出隔开,提高了电路的线性度。