felts
英
美
网络 毛毡; 毡合
双语例句
- Ordinary alumina-silicate refractory fiber felts
GB/T3003-1982普通硅酸铝耐火纤维毡 - This article describes the revising process of Industry Standard "Fibreglass Needled Felts for Filtration" and the main contents of the standard draft reported for approval.
前言：本文描述了《过滤用玻璃纤维针刺毡》行业标准的修订过程和标准报批稿的主要内容。 - The research is focused on upstream and downstream film holes. Effects of Porosity on Gas Permeability and Maximum Pore Size of Fiber Felts
取气膜孔前后3倍气膜孔径范围为研究对象。孔隙度对纤维毡透气性能和最大孔径的影响 - Rule for preparing samples of ordinary alumino-silicate refractory fiber felts
GB/T3008-1982普通硅酸铝耐火纤维毡检验制样规定 - In some papers, the felt finish is made by impressing still-wet paper with variously structured felts.
有些纸，表面的毛布纹是用不同纹理的毛布压向仍然是湿的纸上而成。 - Equipment of felt cleaning system makes the felts longer serrice life.
备有毛毡清洁系统，延长毛毡使用寿命。 - Effects of Porosity on Gas Permeability and Maximum Pore Size of Fiber Felts The Academic Optimization of Cutting Parameter of Machining Small-deep Hole
孔隙度对纤维毡透气性能和最大孔径的影响小直径深孔加工切削用量的实验优选 - Headgear consisting of hat foundations covered with felt chemises ( i.e., handkerchief felts) forming and tapping oils for bolts and nuts formers
帽子，由毛毡塞布（即：薄型毛毡）包盖的帽衬底组成螺丝、螺帽成型攻牙专用油 - In a study of needled felts, crimp was found to be a very influential factor.
对针刺毛毡进行研究后发现卷曲是一项重要的影响因素。 - The Influence of Capillarity in Porous Fiber Felts on Evaporation
非织造纤维类多孔介质的毛细作用对蒸发的影响 - C/ C composites with higher interfacial strength can be obtained by using needle-punched felts from oxidized PAN fiber.
采用PANOF作为纤维材料制毡，可以得到界面强度较高的炭／炭复合材料。 - Microwave absorbing properties of single-layer circuit analog absorbing materials utilizing activated carbon fiber ( ACF) felts as the conducting material are studied.
研究了以粘胶基活性碳纤维为导电材料制备单层电路模拟吸波材料的微波吸收特性。 - Conclusion The polyester felts show differences of histological compatibility in different tissues, however they can be used to repair and rebuild the injured ligament of human body.
结论涤纶毡片在不同组织存在组织相容性差异；能用于修复和重建人体受损的韧带组织。 - It is better than conventional paper machine felts in dewatering characteristics, reduction in paper machine vibration, production cost and efficiency, thus having aroused an extensive interest worldwide.
它在脱水性，纸机振动，使用寿命，生产成本和生产效率方面优于传统的造纸毛毯，由此而引起全世界广泛的兴趣。 - Studies have been made on the preparation and physicochemical properties of activated carbon fibers ( ACF), prepared from felts of rayon, phenol-formaldehyde resin, and polyacrylonitrile.
本文以毡状粘胶纤维、酚醛纤维和聚丙烯腈纤维为原料研制了活性炭纤维（ACF），并考察了它们的物化性能。 - It was introduced that some felts of high quality made by Golden Bear Company for many imported paper machines and homemade ones in this paper.
为适应我国造纸工业的迅速发展，金熊公司在这几年中为国产和进口造纸机提供了价廉质优的造纸毛毯。 - The adsorption properties, wetting ability and electrochemical impedance spectrum properties of graphite felts in vanadium electrolyte were investigated. The results show that adsorption property and wet-ting ability were increased with increasing the extent of oxidation.
研究了不同氧化程度下的石墨毡在钒溶液中的吸附性、润湿性及其交流阻抗图谱（EIS），结果发现随着氧化程度增加，吸附性和润湿性增强； - Development and Study of the Needled Felts of Zircon Refractory Fibers
锆英石质耐火纤维针刺毯开发研究 - Research on Application Technology of New Asphalt Waterproof Felts
新型沥青防水卷材应用技术的研究 - Fiber/ sulfonated SBS composite membranes were made by way of integrating S-SBS with the glass fiber felts, just in connection with the problems of the brittleness and poor strength of S-SBS membranes.
针对S-SBS膜强度较低和干膜较脆的问题，通过复合玻璃纤维毡制备了纤维复合磺化SBS膜。 - With the carbon fiber integrated felts used as preforms, two different types of carbon-carbon ( C/ C) composites, namely, rough laminar ( RL) structure materials and smooth laminar ( SL) structure materials were fabricated by thermal gradient CVI process.
以炭纤维整体毡为预制体，采用热梯度CVI工艺制备了两种不同结构基体炭的C/C材料，即RL结构和SL结构材料。 - Objective To observe the differences of histological compatibility among the polyester felts which were embedded in muscle, fat and tissue under the skin.
目的观察涤纶毡片植入肌肉、脂肪、皮下组织后的组织相容性差异。 - Research on Process of Carbon Felts Self heating Pyrolysis and Deposition
碳毡自加热热解沉积致密化工艺初探 - Anatase TiO 2 particles were prepared on viscose-based activated carbon fiber ( ACF) felts surface via sol-gel method with tetra-n-butyl titanate as precursor and characterized by XRD and SEM.
采用钛酸四正丁酯为原料，用溶胶-凝胶法在粘胶基活性炭纤维（ACF）毡表面制备了锐钛矿型的二氧化钛粒子，并用XRD，SEM进行了表征。 - In order to enhance the heat performance of heat exchanger, this paper designed a miniature laminated heat exchanger with porous copper fiber sintered felts and taken a systemic test for it. 1.
因此，为进一步提高换热器的换热性能，本文通过设计加工出基于多孔铜纤维烧结毡的微小型层叠式换热器，并对其性能进行系统的试验分析研究。 - And the test system was used to test the heat exchanger which adopts porous copper fiber sintered felts which were different type or having different structure, or different types of heat transfer plate.
利用测试系统，测试了采用不同类型和不同结构参数的多孔铜纤维烧结毡、不同分布腔结构换热腔板的换热器的性能。 - A non-toxic, simple, rapid electrochemical modification, so call "anodisation", was used to modify the graphite felt materials ( hard felts).
采用无毒、简单、快速的电化学氧化方法对石墨毡（硬毡）材料进行改性。