ferro-silicon

美 [ˈfɛroʊ ˈsɪlɪkən]

网络  硅铁; 硅钢

机械



双语例句

  1. Optimization of Technological Conditions in Reduction of Lithium by Ferro-silicon Alloy
    以硅铁为还原剂制取金属锂的工艺优化
  2. Formation mechanism of Fe_xSi particles in ferro-silicon nitride prepared via flashing combustion
    闪速燃烧合成的Fe-Si3N4中FexSi粒子的形成机理
  3. The nitridation mechanism of ferro-silicon alloy and the effect of Fe on it are expounded by thermodynamic analysis.
    通过热力学分析,系统地阐述了硅铁氮化合成氮化硅铁的反应机理及Fe在氮化反应过程中的作用。
  4. Analysing the effects of technological fac-tors on smelting metal silicon ( or ferro-silicon) with equilibrium state diagram
    采用平衡状态图分析工艺因素对工业硅(或硅铁)冶炼的影响
  5. Measurement of Ni in Ferro-silicon Alloy by Means of Flame Atomic Absorption Method in the Presence of Triton X-100
    在TritonΧ-100存在下利用火焰原子吸收法测定硅铁合金中的镍
  6. Compensation Analysis of the Ferro-silicon Electric Arc Furnace's Discrete Capacitor
    硅铁电弧炉的分布电容补偿分析
  7. It can save ferro-silicon and reduce cost to add cheap low-silicon iron in molten steel of oxygen top-blown converter to substitute ferro-silicon alloy in full or part to make deoxidation alloying.
    在氧气顶吹转炉钢水中加入廉价的低硅铁全部或部分替代硅铁合金进行脱氧合金化,可以节约硅铁合金,降低炼钢成本。
  8. The three step route-EAF/ LD ( MRP)/ VOD has been developed to reduce argon consumption, refractory requirement and cut down on ferro-silicon use in stainless steel production.
    为了在生产不锈钢时减少氩气消耗和对耐火材料的需求,以及降低硅铁的用量,发展了EAF/LD(MRP)/VOD三步炼钢法。
  9. Sintering experiment of ferro-silicon nitride in air atmosphere
    氮化硅铁在空气气氛中的烧结试验
  10. This method measures Ni in ferro-silicon alloy with a linear range of 0. 2-0. 4 μ g/ ml, and detecting limit of 0. 04 μ g/ ml is suitable for measuring samples in large batch.
    该法测定硅铁合金中镍的线性范围为0.2~0.4μg/ml。检出限为0.04μg/ml。
  11. The influence of rare-earth ferro-silicon inoculating on the structure and properties of crmo-cu martensitic cast iron
    稀土硅铁孕育处理对铬钼铜马氏体白口铸铁组织与性能的影响
  12. Gas control and recovery and utilization of microspheric silica of ferro-silicon
    铁合金烟气治理及硅微粉的回收利用
  13. An Analysis of the Ferro-silicon Electric Arc Furnace
    硅铁电弧炉的电路分析
  14. An X-ray fluorescence method for the determination of Si, Al, Ca, Mn, Cr, P and S in ferro-silicon by the Model ARL 8480 XRF spectrometer is described.
    叙述了用ARL8480型X射线荧光光谱仪测定硅铁中Si、Al、Ca、Mn、Cr、P和S元素的X射线荧光光谱分析方法。
  15. Four technological factors such as coke size, basicity, addition of coke and smelting time were discussed in the carbothermic reduction of red mud obtaining ferro-silicon alloy and calcium aluminate.
    具体的研究内容包括:一、研究了碳热还原赤泥提取硅铁合金和合成铝酸钙的工艺因素,主要探讨焦炭粒度、原料二元碱度、焦炭配量和冶炼时间四个因素。
  16. Three technological factors such as addition of aluminum ash, basicity and smelting time were discussed in the aluminothermic reduction ( using aluminum ash) of red mud obtaining ferro-silicon alloy and calcium aluminate.
    研究了铝热(铝灰)还原赤泥提取硅铁合金和合成铝酸钙的工艺因素,主要探讨了铝灰配量、原料碱度和冶炼时间三个因素。