taker-in
英 [ˈteɪkə(r) ɪn]
美 [ˈteɪkər ɪn]
网络 刺辊
双语例句
- The effect of carding feed plate and taker-in on card sliver quality Size of the coiler trumpet not adjusted to the hank.
梳棉机给棉板与刺辊隔距对梳棉质量影响圈条器喇叭口的尺寸与梳棉条的支数不合适。 - Investigation of the Relationship between Card Waste Intermittent Suction and Card Sliver Quality Study on fiber length distribution of taker-in droppings and card strips
梳棉机车肚间歇吸落棉与生条质量的关系梳棉机刺辊落棉和盖板花纤维长度分布 - The number and size variation of Neps in card sliver have been explored through experiments under different carding output and speed and by use of different type of taker-in.
实验研究了梳棉机在不同产量、不同速度、不同类型刺辊的条件下，生条中棉结的数量和尺寸变化情况。 - It is believed that if nep number increases during scutching process, the taker-in plays a more active role in eliminating the neps while the stationary flat and web purifier do not.
研究认为：清棉过程中棉结数量增加，刺辊对棉结的去除作用很大，后罩板处加固定盖板和棉网清洁器的作用则不大。 - The fiber length distribution of taker-in droppings and card strips under such conditions as three kinds of pin taker-in and one kind of saw-tooth taker-in at speeds of two doffer and four taker-in level are tested with roller cotton fiber length analyzer.
用罗拉式纤维长度测量仪对3种梳针刺辊和1种锯齿刺辊在二档道夫速度和四档刺辊速度的不同工艺条件下的刺辊落棉和盖板花纤维长度分布进行了检测。 - Development and Application of the Pinned Taker-in and the Pre-carding Plate
钢针型刺辊和预分梳板开发及使用实践 - An Approach to the Relationship between Taker-in Speed Fibre Separation and Index of Sliver
刺辊速度与生条纤维分离度关系的研讨 - A shorter distance between feed plate and taker-in shorter distance between feed plate and taker-in gauge is favorable to remove neps and waste, but a longer one will be good to remove seed coat neps.
给棉板与刺辊隔距愈小，对棉结和杂质去除越为有利，但对带籽屑棉结去除以隔距较大时比较有利。 - So the purpose of studying the action of the taker-in part of the carding machine is to intensify carding and in the same time to abate fiber breakage.
对刺辊部分的研究目的在于既加强梳理，又减少梳理过程中纤维断裂。 - Carding Practice of New Taker-in Wires
一种新型刺辊齿条的梳理实践 - Study on fiber length distribution of taker-in droppings and card strips Droppings difference between the saw-toothed taker-in and the gill pin taker-in
梳棉机刺辊落棉和盖板花纤维长度分布锯齿刺辊与梳针刺辊落棉差异的研究 - This paper discuses the velocity ratio of cylinder to taker-in, the roving elongate rate, and the fiber loads between cylinder and flat, and based on the discussion presents some new opinions on the sub-ject.
本文对锡林刺辊间的速比、锡林盖板间的纤维负荷、粗纱伸长率等问题进行了讨论，并提出了若干新见解。