turbocharger

noun

1. 涡轮增压器；透平增压器
   a system driven by a turbine that gets its power from an engine's exhaust gases. It sends the mixture of petrol/gas and air into the engine at high pressure, making it more powerful.

1. Fit intake pipe on turbocharger.
   将进气管安装在涡轮增压器上。
2. Fit oil supply lines for turbocharger with new o-rings.
   使用新的o形圈安装涡轮增压器的供油管。
3. Research on Common Problems and Strategies of Diesel Engine Turbocharger Applied in Construction Machinery
   工程机械用柴油机增压器常见问题及对策研究
4. Fit the intake manifold on the turbocharger using a new screw-type clamp.
   用新的螺旋式卡箍在涡轮增压器上安装进气管。
5. And the intelligent surge-preventing system for diesel engine's turbocharger is introduced from its principle and controlling rules.
   分析了柴油机增压器低温喘振的原因和危害，介绍了开发的柴油机增压器智能防喘装置的原理和控制规律。
6. The experiment on the matching between a variable nozzle turbocharger ( VNT) and CA498Z diesel engine is performed.
   在CA498Z柴油机上进行了可变喷嘴增压器（VNT）的匹配试验研究。
7. Fit turbocharger holder on camshaft housing.
   将涡轮增压器支架安装到凸轮轴室上。
8. Dynamic balance test should be carried out to the rotor of the turbocharger.
   涡轮增压器转子应进行动平衡试验。
9. Loosen the five fastening nuts on the turbocharger.
   松开涡轮增压器上的五个紧固螺母。
10. The turbocharger can be damaged or stop working completely if you rev the engine.
    如果您加快发动机转速，涡轮增压器可能损坏或完全停止工作。
11. Tighten the line on the turbocharger and on the camshaft housing to the specified torque.
    在涡轮增压器上及凸轮轴室上将该管拧紧到规定力矩。
12. To do this, loosen the three fastening screws and pull the turbocharger out sideways.
    为此，请松开三个紧固螺钉并从侧面拉出涡轮增压器。
13. Loosen pressure hose on the turbocharger.
    松开涡轮增压器上的压力软管。
14. Fit the oil extraction line between the turbocharger and oil guide housing.
    安装涡轮增压器和机油导流壳之间的机油抽取管。
15. Turbocharger rotor dynamics considering engine's foundation excitation
    考虑发动机基础激励的涡轮增压器转子动力学研究
16. The Study of Effects of Compound Turbocharger on the Performance and Emissions of LD Diesel Engines
    复合涡轮增压对轻型柴油机性能和排放影响的研究
17. Cleansing of Vehicle-Use Unleaded Gasoline& Gasoline Cleansing Agents; Remove air cleaner hoses from turbocharger.
    车用无铅汽油的清洁化与汽油清净剂从透平增压器上拆下空气净化器油管。
18. Study on Intake Bypass Recirculation System of Turbocharger
    涡轮增压器进气旁通再循环系统的研究
19. The boost pressure is controlled by means of the position of the vanes in the turbocharger.
    涡轮增压器叶片的位置对增压压力起着控制作用。
20. The vehicle variable geometry turbocharger ( VGT) with pneumatic and symmetric nozzle ring vane was researched.
    对应用气动型与对称型喷嘴环叶片的车用可变几何涡轮增压器进行了研究。
21. This paper describes optimized matching research of turbocharger& L360 engine with air-to-air aftercooler.
    介绍了涡轮增压器与L360空对空增压中冷柴油机的优化匹配研究过程。
22. Install turbocharger removing and installing turbocharger.
    安装涡轮增压器拆卸和安装涡轮增压器。
23. The turbocharger uses adjustable vanes for the spontaneous development of torque.
    涡轮增压器通过调整叶轮来实现对发动机自身扭矩的提升。
24. To do this, release the line on the turbocharger and then on the coolant distribution pipe.
    为此，先松开涡轮增压器上的管路，再松开冷却液分配管上的管路。
25. Connect hose to the turbocharger.
    将软管连接到涡轮增压器。
26. An intensity analysis was carried out to the friction weld area of turbocharger shaft with ANSYS finite element analysis software.
    应用有限元分析软件ANSYS，对涡轮增压器轴摩擦焊区域进行了强度分析。
27. Fit the other three lines on the turbocharger with new o-rings.
    用新的o形圈将其他三个管路安装在涡轮增压器上。
28. Exhauster high speed pressure regulator Remove air cleaner hoses from turbocharger.
    真空泵高转速调压器从透平增压器上拆下空气净化器油管。
29. Insert intake air lines into the flanges on the turbocharger.
    将进气管插入到涡轮增压器的法兰中。
30. Unscrew the heat shield covering the catalytic converter and the turbocharger.
    旋开盖住催化转化器和涡轮增压器的隔热板。