The present method is validated through a cantilever beam and a offshore platform. 并通过悬臂梁和海洋平台的数值模拟对该方法进行了验证。
The structure of the flexible-hinge is optimized, and simulation analysis on the strain cantilever is carded out. 优化设计了柔性铰链的结构,对悬臂式应变梁进行了仿真分析。
Through the active control testing on composite material cantilever beam, the process of vibration absorbed is carried out. 通过对悬臂的复合材料梁实施主动控制试验,实现了减振控制过程。
Topology optimization design of minimum weight cantilever trusses subjected to stress constraints is studied. 研究了应力约束下最小重量悬臂梁桁架结构的拓扑优化设计。
As an example, the frequencies of a composite laminated cantilever plate are calculated. 作为例题,计算了复合材料悬臂层合板的频率。
With the system, the stresses of arch dam are computed based on crown cantilever method; 对毛坦砌石拱坝进行了温度场和应力场全年仿真计算;
As an important part of superstructure of cantilever beam system, corbel's stress state is very complex. 牛腿是悬臂体系梁桥上部构造的一个重要组成部分,其应力状态较为复杂。
These building techniques are post and lintel, arch and vault, truss, and cantilever construction. 这些建筑技术在工艺上的成果就是柱子、门楣、拱门、拱顶,桁架和悬桁。
Cantilever constructional requirements and controlling methods of continuing bridge 连续梁桥的悬臂施工要求和控制方法
Monitoring of Construction and Test under Vehicle Load for Large Boxed Girder with Cantilever Assembled Spines; 大型悬臂拼装脊骨箱梁桥施工监测与车载试验研究拼盘里装的是什么菜呢?
Analysis and Studies on Structural Design of Transverse Bridge Cantilever 桥梁横向大悬臂结构设计的分析和研究
The flow sensor has a structure of cantilever beam with ridge waveguide. 流量传感器具有带脊型波导的悬臂梁结构。
Finite Element Analysis of Continuous Girder Bridge in Cantilever Construction 某连续梁桥悬臂施工中的有限元仿真分析
Approximately one-third of the span from the pier may be erected by the free cantilever method. 大约三分之一的跨长可以由一个桥墩起靠自由悬臂的方法向前架设。
The author introduces the technique of cantilever turn-over formwork and gallery formwork used for Baise RCC main dam. 介绍了百色碾压混凝土大坝悬臂翻升模板及廊道模板的设计和施工工艺。
An experimental cantilever beam example shows that the method can detect crack location with satisfactory precision. 对悬臂梁结构测试例子的分析表明,该方法能较好地识别具有单个裂纹结构的裂纹位置。
Bending behaviors of functionally gradient piezoelectric curved cantilever was studied. 摘要研究了弯曲型梯度功能压电悬臂梁的弯曲特性。
Most cantilever bridges have two arms of truss structure that meet or support a section between them. 大多数悬臂桥都有两个桁架臂用以对接或支撑两臂之间的桥段。
Vertical elements carry sufficient load through cantilever action to produce cantilever deflections equal to arch deflections. 垂直杆件则借悬臂作用产生和拱挠度相等的悬臂挠度,来承担足够的荷载。
The dynamics of a cantilever beam attached to a rotating rigid body is reported in this paper. 本文对固结在转动刚体上柔性梁的动力学问题进行了研究。
Cantilever and catenary are calculated individually for each span length on the construction site. 在施工现场分别计算腕臂和悬链线的跨距。
Finally, this proposed method is applied to designing the optimal locations for measuring the asymmetric bending deformation of a cantilever rectangular plate. 应用该方法对悬臂矩形板弯曲变形实测进行了测点优化布置,组合优化数值结果验证了该方法的可行性和有效性。
Torque cantilever with bismuth crystal. 扭矩悬臂与铋晶体。
Based on the analytical and numerical method, free vibration of the cantilever beam with rotating motion is analyzed. 分析转动悬臂梁的自由振动问题,通过综合运用解析法和数值方法解决悬臂梁振型函数过于复杂的问题。
The structure consists basically of two cantilever beams. 这种结构基本上由两根悬臂梁组成。
The modelling problem for a cantilever beam with a controllable constrained damping layer is discussed in detail. 建立了可控约束阻尼层悬臂梁的动力学模型,分析了模型中的不确定性。
The Shape and Stress Control of Symmetrical Cantilever Construction Bridge 对称悬臂施工桥梁的线形和应力控制
A linear state error feedback control technique is utilized to synchronize two coupling cantilever beam system. 研究了一类利用线性状态误差反馈控制方法耦合的非自治悬臂振动系统的全局混沌同步。
A movable temporary stay arrangement must be used to limit the cantilever stresses during construction to a reasonable level. 必须采用一个可移动的临时拉索装置将施工过程中的悬臂应力限制在合理的范围之内。
A cantilever beam was experimentally studied with this method and the result is consistent with theoretical result. 以悬臂梁为例进行实验研究,实验结果与理论计算结果吻合较好。