An approach to measure friction of AC servo motion control system by measuring the output torque was proposed. 提出了一种通过测量交流伺服电机输出扭矩间接测量摩擦的方法。
The inner loop adopts sliding mode control which can decouple torque and flux. 内环采用滑动模控制实现了电动机转矩和磁通的解耦。
The back EMF constant and torque constant are analyzed. The calculating formulas are gived. 分析了电机的反电势常数和力矩常数,并给出了计算公式;
Abstract: this paper introduces the structure, working principle and its application of torque control screw. 文摘:介绍了扭矩控制螺栓的结构和工作原理以及它的应用。
Second, this dissertation develops the qualitative and quantitative analysis methods for cogging torque. 其次,本文发展了齿槽力矩的定性和定量分析方法。
Special thanks to professor Meng to my calculation of the casting ladle shaft and maximum torque, check calculation. 特别感谢的是:孟教授对我计算的浇包轴位置和最大扭矩,进行了校核计算。
I torque for time delta t, and so I add angular momentum like this. 我的力的时间是δt,我加入,了角动量像这样。
Using the numerical calculus and derivation, the calculation model of system driving torque was established. 通过数值计算和推导,建立了系统驱动力矩计算模型;
The LPV direct torque control used a method of stator voltage space vectors subdivision to decrease the torque pulsation. 结合定子电压空间矢量细分方法,可减少电磁转矩的脉动,实现了LPV直接转矩控制。
Now you generate a torque which is linearly proportional to the angle. 现在产生一个力矩,和这个角成比例。
I've given it a little torque. 我将要给了它一个力矩。
The structure of the damper is determined, and a damping torque model is established. 确定了该阻尼器的结构,建立了阻尼器的阻尼力矩模型。
This paper analyzes the Direct Torque Control ( DTC) theory of PMSM. 分析了永磁同步电机直接转矩控制理论;
Development on measuring system for frictional torque of ball screw; 介绍了滚珠丝杠副摩擦力矩虚拟测试系统的设计方案。
Plots the torque speed curve and power curves for given values of stall torque and no load speed. 绘制给定失速扭矩和空载速度时的力矩曲线和功率曲线,不含负荷转速。
A cogging torque measurement system was proposed, which was composed of stepping motor, torque sensor, etc. 提出了一种由步进电机、转矩传感器等元件组成的齿槽转矩测试系统。
This article deals with torque allocation for redundant flywheel configurations in a spacecraft attitude control system. 主要研究了航天器姿控系统中冗余飞轮构型的力矩分配问题。
No monitoring and control requirement on screwing torque. 没有要求对对螺丝扭力进行监测及控制。
In this paper, speed and torque regulation of the induction motor based on the passivity are investigated. 本文主要研究了基于无源性的感应电机的转矩和转速控制。
A simulation method of direct torque control system of induction motor is presented, based on MATLAB. 介绍了一种基于MATLAB的异步电动机直接转矩控制系统的仿真方法。
Finally the single-chip flywheel torque servo controller was implemented on a system level ASIC. 给出了实现飞轮力矩伺服控制算法的系统级ASIC结构。
The measurement method on dynamic torque of power plant home and abroad is introduced. 介绍了动力装置动态扭矩测试的国内外现状和动力装置轴系动态扭矩直接测试法的原理和技术途径。
A control system of bearingless induction motor based on torque winding air gap field oriented vector control is accomplished. 实现了一种基于转矩绕组气隙磁场定向控制的无轴承异步电机控制系统。
Five-and six-phase motors can offer better torque ripple reduction compared with four-phase and three-phase. 五和六阶段马达可能提供更好的扭矩波纹减少比较四阶段和三相。
The torque relative to point P is now very similar to what we had with a spring. 和点P相关的力矩,和弹簧非常相似。
The applications in torque controlling of electric vehicle drive system verified the effectiveness. 在电动汽车中的实际应用验证了这种方法可以满足转矩控制的要求。
Rotating bearing plate reduces internal loading for lower starting torque and long-life operation. 旋转支承板,降低了较低的起动转矩和长寿命运行的内部装载。
It also gave the hardware of the control system and the design of the finger's impedance torque controller. 给出了控制系统的硬件实现和手指阻抗力矩控制器的设计。
The paper introduces a new type torque sensor used in robots joint and analyzes its working principle. 介绍了一种用于机器人关节上的新型力矩传感器,分析了力矩传感器的工作原理。
A new digital torque and rotational speed measurer is introduced in this paper. 介绍了一种新型的数字式转矩转速测量仪。